100W Power Supply for Linear LED Lamps for Fence Posts – 24V | 100W

Installation of LED Lamp in Fence Post

1. Insert the lamp into the post profile – slide the lamp from the top into the dedicated slot in the post (designed for mounting lamps or trims)
2. Route the cables from the lamp – guide them inside the post or through the hole at the base
3. Connect the lamp to the power supply (see instructions below)
4. Place the power supply in a dry location (e.g. sealed box, technical enclosure)
5. Connect the power supply and test:
   • Once the lamp and 230V power are connected, the lamp should light up.
   • Check correct operation – no flickering, even illumination.

Connecting a Linear LED Lamp to 100W 24V Power Supply

Prepare the components:

• Linear LED lamp (24V DC)
• 100W / 24V DC power supply
• 230V power cable (with plug or for electrical box connection)

Connect 230V to the power supply input (“INPUT”):

• L (live) – brown wire
• N (neutral) – blue wire
• ⏚ (earth / PE) – yellow-green wire

Ensure that the wires are properly secured and tightened in the terminal block.

Connect the lamp to the power supply output (“OUTPUT”):

• V+ – red wire from lamp (positive)
• V– – black wire from lamp (negative)
• If the power supply has 2 pairs of V+ and V–, you can use either pair.

Check all connections:

• Ensure all screws are firmly tightened.
• Ensure correct polarity (red to V+, black to V–).

Connect the power supply to 230V:

• Plug into a socket or wire into the electrical system.
• The lamp should light up after a moment.

Important Notes:

• The power supply is not waterproof – install it in a dry location or sealed enclosure.
• Do not work with live power – always disconnect before servicing.
• Do not exceed the power supply's maximum output – always leave at least 10–20% power reserve.