Linear LED Lamp for Fence Post – 150 cm (9W)

LED Lamp Installation in Fence Post

1. Place the lamp into the post profile – slide it from the top into the dedicated slot in the post (designed for lamps or trims)
2. Route the wires from the lamp – feed them inside the post or through the hole at the base
3. Connect the lamp to the power supply (see instructions below)
4. Place the power supply in a dry location (e.g. sealed box, technical enclosure)
5. Connect the power supply and test:
   • After connecting the lamp and 230V power – the lamp should light up.
   • Check for proper operation – no flickering, even illumination.

Connecting a Linear LED Lamp to 100W 24V Power Supply

Prepare the components:

• Linear LED lamp (24V DC)
• 100W / 24V DC power supply
• 230V power cable (with plug or for terminal box)

Connect 230V to the power supply input (“INPUT”):

• L (live) – brown wire
• N (neutral) – blue wire
• ⏚ (earth / PE) – yellow-green wire

Ensure the wires are properly twisted and securely fastened in the terminal block.

Connect the lamp to the power supply output (“OUTPUT”):

• V+ – red wire from the lamp (positive)
• V– – black wire from the lamp (negative)
• If the power supply has 2 pairs of V+ and V–, you can use either one.

Check the connections:

• Ensure all screws are securely tightened.
• Make sure the polarity is correct (red to V+, black to V–).

Connect the power supply to 230V:

• Plug it into a socket or connect the cable to the mains.
• The lamp should light up after a moment.

Important notes:

• The power supply is not waterproof – install it in a dry location or in a sealed enclosure.
• Do not work with live current – always disconnect the power first.
• Do not exceed the power supply’s maximum load – leave at least 10–20% power reserve.